Activating call accounting for Alcatel

Alcatel 4200 E

You have to do the following settings using your Alcatel programming software (MMC).

If you don't have a cable you'll need to make the wiring directly on the CM board.

Connect X7, X8 : 10 pin BURNDY connector for connecting a pulse metering device (X7) and the MMC PC (X8). The terminals connected to these interfaces must be classified S.E.L.V.

Pin no.SignalFunction
1REMOTE Signal used for remote access
2RXD 104 - Reception
3TXD 103 - Transmission
4DTR 108 - Data Terminal Ready
50V Ground
6DCD109 - Carrier Detection
7RTS105 - Request To Send
8CTS106 - Clear To Send
90VGround
10GND102 - Signalling Ground
ImageImageImage

Alcatel OmniPcx Office (OXO)

The default address of the pbx system is 192.168.0.254 and the port for ftp is 30021. You need to set in the PbxMon setup in the remote server address:port the following string: 192.168.0.254:30021. Also you must use user ftp_nmc and password tuxalize.

Alcatel OmniPcx Enterprise and 4400 (OXE)

The default address of the pbx system is 192.168.0.254 and the port for ftp is 21. You need to set in the PbxMon setup in the remote server address:port the following string: 192.168.0.254:21. Also you must use user mtcl and password mtcl.
Last Updated ( Monday, 04 June 2007 )
 
< Prev
[ Back ]